Roman blind installation
Bracket fitting options
The brackets can be fitted in the following ways:
Marking the bracket positions
Position
the brackets in
place at the correct position
for the blind and mark
the fixing points per
bracket.
Marking/drilling the bracket positions
Fix the brackets in using
suitable
fixings.
Mounting the
R
oman blind
While tilting the blind headrail at
a slight angle, locate the fabric
side horizontal groove that runs
along the top section of the
headrail into the front hook of
the bracket (fig 1).
Push the front of the headrail in
to compress the bracket springs
and rotate the headrail up to
locate the horizontal groove
situated at the rear of the
headrail until it clicks into place
(fig 2).
Allow the spring to release and
secure the headrail in place.
Removing the blind - Start at one end of the blind and:
1) Push the headrail in to compress the bracket spring.
2) Tilt the headrail down at the rear and unhook the headrail
from the rear secction of the bracket.
3) Repeat ensuring that the headrail is adequately supported.
5
Electra Top Tip!
If securing the brackets to plaster,
stone, brick, etc., drill the holes at the marked
positions using a 5.5mm masonry drill bit, then use
the wall plugs and screws supplied to fix the brackets.
