Elecro Engineering Koolsmart PLUS, Инструкция по установке и эксплуатации

Страница: 12 / 19

12
Probe calibration is usually not required. However, should you need to make an adjustment take a
temperature reading from the pool water with an accurate thermometer then adjust as required.
Actual Water Temp Koolsmart Plus Reading Adjustment Required
28 30 -2.0
28 26 2.0
6.6 MODBUS Setup
Refer to your BMS Management System manual for the required settings.
SET BAUD touch the
‘O.K’
button key to select,
‘MODBUS SET BAUD’
will be displayed, touch the
‘O.K’
button key
to select and
‘SET BAUD 19200 Baud’
will be displayed, touch the
‘UP’ / ‘DOWN’
button keys
for the other option
‘SET BAUD 9600 Baud’
touch the
‘O.K’
button key to select the required,
Baud rate.
Set Address
Touch the
‘UP’
button and
‘MODBUS SET ADDRESS’
will be displayed, touch the
‘UP’ / ‘DOWN’
button
keys to set the required address, touch the
‘O.K’
button key, the display will revert back to show
‘MODBUS
SET ADDRESS’
.