Elecro Engineering Koolsmart PLUS, Инструкция по установке и эксплуатации

Страница: 11 / 19

11
6.4 TIMER Setup
After selecting
‘O.K’
for the
‘CLOCK’
setup the display will then revert back to s
how ‘CLOCK’, touch the
‘UP’ / ‘DOWN’
button keys until
‘TIMER’
is displayed, touch the
‘
O.K
’
button key to select,
‘TIMER 1’
will
be displayed, touch the
‘O.K’
button key to select and
‘SET TIMER 1 ON’
will be displayed, touch the
‘UP’
/ ‘DOWN’
button keys to set the required time, touch the
‘O.K’
button key to save the setting,
‘SET TIMER
1 OFF’
will be displayed, touch the
‘UP’ / ‘DOWN’
button keys to set the required time, touch the
‘O.K’
button key to save the required time, the display will then show
‘TIMER 2’
repeat the same procedure for all four
‘ON’ / ‘OFF’
timer settings, select
‘EXIT’.
If any Timers
are not required set the
‘ON / OFF’
times the same.
The timer mode allows you to set up 4 on and off time periods when you would like cooling to
take place. These can be set to take advantage of off-peak energy tariffs, or to ensure your pool
is at the required temperature during specific time periods.
Note: The time clock will only control the cooling time periods and not the filtration pump cycles.
6.5 Probe Calibration Setup
After selecting
‘EXIT’
for the timer setup the display will then show
‘PROBE CAL’
touch the
‘O.K’
button key to select, touch the
‘UP’ / ‘DOWN’
button keys to increase or decrease the temperature
calibration adjustment, touch the
‘O.K’
button key to select, the display will then revert back to
show
‘PROBE CAL’
.