21
Care of this equipment
To care for the gel pad, disconnect it from the main unit.
■
Servicing gel pads
The gel pad needs to be cared for in the following situations:
• Gel pad has lost adhesiveness
• When stimulation during use has weakened
• When stimulation during use feels strengthened
• When the gel pad is dirty
• Gel pads do not stick to the protective plate
Replace the gel pad if you feel there is not enough/too much stimulus during use even after
caring for the gel pad.
①
Drip a few drops of water and rub with the ball of a finger to remove lifted contaminants
※ Do not pour too much water. It will cause loss of adhesive strength or damage to the ad-
hesive surface.
※ Do not scrape the surface with a nail or a brush.
※ Do not use any detergent or the like.
※ Prevent dripping water drops on a plug, electrode cord or handle.
②
Hold on the handle and thoroughly eliminate water and dry naturally with pad surface facing
up, ensuring that no water drop drips onto the handle.
※ With insufficient drying, the adhesive strength becomes weak.
※ Never wipe the adhesive surface with tissue paper or a cloth.
※ Avoid direct sunlight.
■
Servicing base unit
• When the main unit is dirty, wipe it with a dry soft cloth.
Take care not to allow water etc. to enter the Main Unit or the USB connector port.
Adhesive surface
Handle
CAUTION:
