10
EN
- during vacuuming, the suction power can be adjusted using the adjuster
(2, 13)
,
- observe the bag-full indicator
(6)
; if its colour changes from white to red, empty the canvas bag
(17)
or replace it for the paper bag.
NOTE: Never vacuum if the indicator (6) has turned red.
- press the “
ON/OFF
” switch
(4)
to stop the appliance,
- after work is completed, disconnect the power cord from the mains and rewind it by pushing and holding down the switch
(1)
.
Hold the power cord firmly to prevent its uncontrolled movement.
BAG - EMPTYING / REPLACING
Before any operation, switch off the appliance using the switch
(4)
and disconnect it from the mains. Press the switch
(1)
to rewind
the power cord.
Canvas bag (17) - emptying:
- remove the hose
(12)
from the seat
(7)
by pressing the corrugated parts at the end of the hose and pulling upwards,
- press the lock switch
(8)
, swivel the lid
(5)
, and place the vacuum cleaner vertically,
- pull out the frame with the installed bag,
- slide the plastic strip off the bag (
Fig. 3
) and empty it - fasten the slide back,
- install the frame with the bag in the vacuum cleaner,
- close the lid
(5)
.
Paper bag - replacement:
Instead of a canvas bag
(17)
, you can use paper bags model
ELDOM OSW1700
.
- remove the hose
(12)
from the seat
(7)
by pressing the corrugated parts at the end of the
hose and pulling upwards,
- press the lock switch
(8)
, swivel the lid
(5)
, and place the vacuum cleaner vertically,
- pull out the frame with the installed bag,
- remove the old bag from the frame and insert the new bag by inserting the bag’s plate into the frame’s guides,
- install the frame with the bag in the vacuum cleaner,
- close the lid
(5)
.
FILTERS
Check the condition of the filters
(15, 16)
regularly and replace them periodically.
The vacuum cleaner is equipped with two filters:
- the internal inlet filter
(16)
protects, among others, the motor against damage. The filter can be accessed by opening the lid
(5)
and pulling out the dust bag
(17)
,
- external filter
(15)
is a protection against air pollution in vacuumed rooms. The filter can be accessed by opening the filter lid
(15)
-
Fig. 1
.
The frames of the external and internal filters can be washed with water.
Never wash the cartridges; replace them periodically.
RECOMMENDATIONS AND TIPS
- The vacuum cleaner can be stored in the vertical or horizontal position. On the back of the appliance, there is a handle for parking
the suction tube, and there is an appropriate catch on the brush
(10)
.
- It is recommended to reduce suction force with the controller
(13)
, when vacuum cleaning of upholstery, rugs, or delicate fabrics.
- If the cable is jammed when coiling, it is recommended to pull it out a little, and then try coiling it again;
- Use the dual-function tip
(18)
to clean hard-to-reach places (corners, gaps, etc.) This component is also equipped with a brush,
which enables removing dust from furniture, books, etc.
CLEANING AND MAINTENANCE
- Before maintaining or repairing of the appliance, switch it off and disconnect from the power supply.
- Clean the appliance, replace the filters
(15, 16)
, and empty the container at regular intervals to ensure the proper operation of the
appliance.
- The housing, accessories, and the power cable should be cleaned with a soft cloth slightly damped with a dishwashing detergent.
- Do not immerse the appliance in water.
- Do not use any aggressive washing detergents for cleaning, as they can damage the housing surface.
ENVIRONMENTAL PROTECTION
•
the appliance is made of materials which can be recovered or recycled
•
the appliance should be handed over to the appropriate centre of collection and recycling of electrical and electronic equipment.
WARRANTY
•
the appliance is intended for personal use at a household,
•
it is not intended for professional purposes,
•
in case of misuse, the warranty is rendered null and void.
Fig. 3
