Eldes ESIM021, Руководство пользователя

Страница: 2 / 7

2
Copyright © “ELDES UAB”, 2010. All rights reserved
It is not allowed to copy and distribute information in this document or pass to a third party without advanced written autho-
rization by “ELDES UAB”. “ELSDES UAB” reserves the right to update or modify this document and/or related products without
a warning. Hereby, ELDES UAB declares that this GSM Alarm and control system ELDES ESIM021 is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC. The declaration of conformity may be consulted
at www.eldes.lt/ce
Manual v1.1
Safety instructions
Please read and follow these safety guidelines in order to maintain safety of operators and people around:
• Alarm and control system ESIM021 (later referenced as system) has radio transceiver operating in
GSM850/900/1800/1900 bands.
• Don’t use the system where it can be interfere with other devices and cause any potential danger.
• Don’t use the system with medical devices.
• Don’t use the system in hazardous environment.
• Don’t expose the system to high humidity, chemical environment or mechanical impacts.
• Don’t attempt to personally repair the system.
• System label is on the bottom side of the device.
The WEEE (Waste Electrical and Electronic Equipment) marking on this product (see right) or its documentation indi -
cates that the product must not be disposed of together with household waste. To prevent possible harm to human
health and/or the environment, the product must be disposed on in an approved and environmentally safe recycling
process. For further information on how to dispose of this product correctly, contact the system supplier, or the local
authority responsible for waste disposal in your area.
System ESIM021 is a device mounted in limited access areas. Any system repairs must be done only by qualified,
safety aware personnel.
The system must be powered by main 9-15V 300mA power supply which must be approved by LST EN 60950-1
standard and be easily accessible.
Any additional devices linked to the system ESIM021 (computer, sensors, relays etc.) must be approved by LST EN
60950-1 standard.
External power supply must be reachable and can be connected to AC mains only inside
installation room with automatic 2-pole circuit breaker capable of disconnecting circuit
in the event of short circuit or over-current condition. Open circuit breaker must have a
gap between connections of more than 3mm.
Mains power must be disconnected before any installation or tuning work starts. The system installation or mainte -
nance must not be done during stormy conditions.
The device is switched off by 2-pole circuit breaker.
Fuse F1 type – miniSMDC 0,5A. Replacement fuses have to be exactly the same as indicated by the manufacturer.
Phase
DC 9-15V
Null
PE
ESIM021