Elcon Elconnect next EAD 100w, Краткое руководство по эксплуатации

Страница: 26 / 36

EAD 100w
Version: 2013/04/03
24
In default state your EAD 100w has been preset as Access Point with below parameters:

Channel: 6

SSID: see label

Security setting: WPA2/PSK

Code: see label

Transmit power: 100%
To connect one or several computers via WLAN with the network, it is necessary to enter the
aforementioned settings on your WLAN adapter. This requires that prior to this the WLAN
adapter has been duly installed on your computer. The relevant installation instructions can be
found in the documentation about your WLAN adapter.
After the initial start-up of your WLAN system has been completed successfully, it is recom-
mended to match your preconfiguration and your password to your individual requirements.
For example, you may change the transmission channel, in case the preset channel has been
occupied (which can be seen in the network status of your WLAN adapter). After first start-
up, you should change the security code and the standard passwords, as well as the device-
specific SSID. Upon entering the WLAN-Key, pay attention to case sensitivity. This settings
have to be transferred to WLAN Access Point, too.
To ensure the highest safety level, select the security setting WPA2 with AES. If your WLAN
adapter does not support the safety protocol WPA2/WPA, then change the encryption mode in
your EAD 100w to WEP.
If you wish to change your WLAN settings, please proceed as described in chapter 3.
2.9 Maintenance
Your EAD 100w is maintenance-free. For cleaning please use a dry cloth. Never use aggres-
sive or caustic detergents.
Before cleaning, remove the power supply unit out of the socket, or put the device
out of operation.
2.10 Uninstallation of the EAD 100w
To uninstall the EAD 100w, first disconnect all cables, starting with the power supply unit.
After all cables are removed, the device can be taken from the wall.