Elcon Elconnect next EAD 100w, Краткое руководство по эксплуатации

Страница: 22 / 36

EAD 100w
Version: 2013/04/03
20
tion, it has no mains switch. For disconnection from the electricity grid, just remove the plug-
in power supply unit. So the wall power supply should always be easily accessible.
Prior to wall mounting, make sure that there are no concealed supply lines (power, water, gas,
telephone, coaxial or fiber cable) at the intended installation place. During operation, the
EAD 100w is markedly warming up, but this operating temperature is not dangerous at all.
However, to provide for unimpeded heat dissipation, the EAD 100w must not be installed into
a fully closed casing, lacking of a sufficiently dimensioned breather hole. For the same reason
the device shall also be protected from intensive heating, caused e.g. by heating appliances or
direct sun radiation. Further, do not expose the modem to a very humid or dusty environment.
The mounting instructions can be found on the drilling template.
2.4 Interfaces and LEDs
Top and side view
Figure 3: Top and side view of the EAD 100w
WLAN
ante
nna
DC
-socke
ts
RJ45
-socke
ts
(LAN)
RJ45
-socke
t
(W
AN
)
RJ11
-socke
ts
(a
nal
og. Te
lephone)
WLAN
a
nte
nn
a
LED
s
WLAN
butt
on
Reset
but
ton