ELCOM Euro-200T, Руководство пользователя

Страница: 43 / 92

43
Programming manual
Second Euro currency phase
In the second Euro currency phase the main currency is Euro, the secondary one is the national currency,
i.e. main and secondary replace each other (replaced are currency description code, displaying and roun-
ding flags). The customer can pay either in Euro or in the national currency. ECR grand totals will be erased
by transition into the second phase. The transition is possible only if daily, periodical and PLU report in “Z”
mode are performed. Reversal into first Euro currency phase is impossible without resetting the ECR. Call
your service technician in that case.
Entering into the second Euro currency phase procedure:
1) Switch the ECR to the “P” mode by pressing

.
2) Enter the code by pressing  .
3) Enter the actual exchange rate ( maximum rate is 10 000, minimum rate is 0,0001 and maximum num-
ber of digits is 9 with maximum 4 decimals) and press

( S
UBTOTAL
).
After programming, the information about transition into second phase of Euro currency is displayed. The
same information is also printed out along with values entered during the transition.
After transition to second phase, it is necessary to change prices of PLU articles and DPTs, as this is not
done automatically.
During the second Euro phase the actual exchange rate can be set by the following procedure:
1) Switch the ECR to “P” mode by pressing

.
2) Press the  ( D
RAWER
) key.
3) Enter the current Euro exchange rate (maximum currency value is 10 000, minimum currency value is
0,0001 and maximum number of digits is 9 with maximum 4 decimals) and press

( S
UBTOTAL
).
Before change is applied it is necessary to perform total (daily) „Z“ report.
Third Euro currency phase
The main currency is the Euro, the secondary currency is any foreign currency, i.e. the secondary currency
is programmable. The customer can pay either in Euro or in the secondary foreign currency. Transition to
the third Euro currency phase is possible only after daily (total) and monthly (periodical) report in „Z“ mode
is performed. Reversal to second Euro phase is not possible without resetting the ECR. Call your service
technician in that case.
Entering into the third Euro currency phase procedure:
1) Switch the ECR to the “P” mode by pressing

.
2) Enter the code by pressing

.
3) Enter the acronym for the secondary foreign currency (three characters maximum) and press

( S
UBTOTAL
) key.
4) Enter the exchange rate (minimum rate is 0.000 1 and maximum is 10 000) and press

( S
UBTO
-
TAL
) key.
5) Enter currency flags according to figure 3.20 and press

( S
UBTOTAL
).
After programming, the information about transition into the third phase of Euro currency is displayed. The
same information is also printed out along with values entered during the transition.
During the third Euro phase the actual exchange rate and secondary currency can be set by the following
procedure:
1) Switch the ECR to the “P” mode by pressing  .