elco Trinox 1000, Руководство по эксплуатации и техническому обслуживанию

Страница: 10 / 22

Trinox Floor Standing Shell and Tube Boiler
10 L344
©
Elco UK 04/07/2012
After connection to the hydraulic system, ensure that the latter is completely de -aerated.
You are advised to insulate the heating system pipes to avoid heat dispersion resulting in increased
fuel consumption and environmental pollution.
ELECTRICAL SYSTEM AND CONNECTIONS
The electrical system must comply with the current regulations and be installed by professio nally
qualified personnel.
Electrical safety of the equipment is ensured only when it is correctly connected to an efficient earth
system in compliance with the current safety regulations.
The manufacturer will not be liable for any damage caused by failure to earth the system.
Call professionally qualified personnel to check that the electrical system is suitable for the
maximum power absorbed by the equipment, ensuring in particular that the system cable sections
are suitable for the power absorbed by the equipment.
Adapters, multiple sockets and extension leads must not be used for general power supply of the
equipment from the mains.
For connection to the mains, a twin-pole switch must be provided in compliance with the current
regulations.
The control panel is already installed on the boiler.
Power supply: 220 V - 50 Hz.
By unscrewing the self-tapping screws, open the instrument panel and connect the boiler
electrically.
All the instruments capillary probes of the panel are located in the bulb on the heating system flow
connection.
Electric connections must be performed following the attached electrical diagram.
Never fix the electric cables to the front part of the boiler, to the doors or the smokebox.
Finally, close the panel.