ELC dmXLAN node6x, Руководство пользователя

Страница: 7 / 12

__________________________________________________________________________________
ELC dmXLAN node6x User Manual
DMX port as output
When a port is set up as a DMX output it can operate in the following modes;
•
Disabled

the DMX output is disabled
•
Outzero

the DMX sends out a DMX test signal with all channels at 0%
•
Single

the output sends out the DMX values of the selected (primary)
Art-Net universe. The DMX output is enabled the first time it detects the DMX
universe on the network (or internal DMX inputs). If the universe on the
network fails, the DMX output will go into DMX hold.
•
Dual HTP

like single, but merges two DMX universes (primary and
secondary) in highest takes precedence
•
Dual LTP

like dual HTP but in latest takes precedence (on a channel by
channel basis)
•
Dual Custom

setting used when programmed via dmXLAN software
•
Priority

as long as the primary universe is active, it will be on the
output – otherwise the secondary universe is sent on the output
•
Softpatch

setting used when programmed via dmXLAN software
•
Flexpatch

setting used when programmed via dmXLAN software
The primary and secondary universes can be set to either Art-Net or sACN (streaming
ACN, both draft R2 and release R3 are supported).
Select the primary or secondary and press the encoder to change it.
This will trigger the universe edit screen;
This is where the universe type can be changed (Art-Net, sACN or disabled).
For Art-Net, you can set the subnet and ID. For sACN, you can set the universe and
the range. The purpose of setting the range is to jump to universes on a higher
number more easily (in increments of 100 up to 65000).
The Resend option can be used to send the merged signal onto the network again as
a new universe. This is helpful when
– for example – 3 universes need to be merged
together.