ELC dmXLAN node6x, Руководство пользователя

Страница: 8 / 12

__________________________________________________________________________________
ELC dmXLAN node6x User Manual
The Rate option can be used to set the rate of the dmXLAN node6x to either;
•
Sync

the DMX output is synchronized to the universe data on the
network. This is the fastest (lowest latency) setting.
Note: some equipment might not cooperate with this setting very well.
•
Fixed rate

use this setting if the sync mode doesn't work (40/33/25 fps)
•
Safe mode

this mode has a long break and Mark After Break – to be used
if none of the above mentioned settings work
The Hold option means that the DMX port will keep sending out the last received
data on the network for as long as it does not receive new data from the network.
The default for
this option is ‘A lways ’ . This setting can be changed to time out after a
chosen time interval.
DMX port as input
When a port is set up as a DMX input it can operate in the following modes;
•
disabled

the DMX input does nothing
•
normal

any valid DMX is sent onto the network (and internal use)
using the selected universe (Art-Net)
•
backup

the DMX input will not send data if the selected universe is
present on the network. If the selected universe is not present on the network
for several seconds and the input has valid DMX, then it will send DMX data.
If another sender starts sending the same universe, the input will go back into
backup mode.
Set ID
If the node3 is being controlled by the dmXLAN software, an ID can be assigned to the
unit. The ID can be useful for preprogramming of the network.
Use the encoder in “Select” and “Edit” mode to change the 3 digits of the ID . The
digits are in hexadecimal format (16 possibilities 0-9, A-F). This means you can have
up
to 4095 different ID’s in the system (ID 000 means that the ID is not used ---).