9
• Briefly press the Start/Stop button, to interrupt the baking process or pull the power plug out of the
wall outlet.
• Open the appliance lid and take out the baking mould. You can take the dough out with floured
hands and remove the kneading blades.
• Replace the dough and close the appliance lid.
• Push the plug back into the wall outlet and press the Start/Stop button. The baking program is
continued. Let the bread cool for 15-30 minutes before eating. Before cutting bread, make sure that
no kneading blade is still in the baking mould.
WARNING DISPLAY
Before opening the appliance lid, pull the power plug out of the wall outlet. When not in use, the
appliance should never be plugged in!
Do not attempt to start operating the bread maker, before it has either cooled down or warmed up.
If the display shows “HHH” after the program has been started, it means that the temperature inside
of bread pan is too high. You should stop the program and unplugged the power outlet immediately.
Then open the lid and let the appliance cool down completely before using again (except the program
of BAKE and JAM). If the display shows “LLL” after the program has been started, it means that the
temperature inside of bread pan is too low. You should place the bread maker on a higher
environment for using (except the program of BAKE and JAM). If the display shows “EE0” after you
have pressed Start/Stop button, it means the temperature sensor open circuit, please send to the
authorized service centre for inspection and repair. If the display shows “EE1”, it means the
temperature sensor short circuit.
CLEANING AND MAINTENANCE
Disconnect the appliance from the wall outlet and let it cool down before cleaning.
1.
Bread pan: remove the bread pan by turning it in anti-clockwise, then pulling the handle, wipe
inside and outside of pan with damp clothes, do not use any sharp or abrasive agents for the
consideration of protecting the non-stick coating. The pan must be dried completely before
installing. Note: Insert the bread pan and press down until it fixed in correct position. If it cannot
be inserted, adjust the pan lightly to make sure it is on the correct position then turn it in clockwise.
2.
Kneading blades: If the kneading blades is difficult to remove from the bread, use the kneading
paddle remover. Also wipe the blade carefully with a cotton damp cloth. If the kneading blade are
incrusted and hard to release, fill the bread pan with hot water for approx. 30 minutes. If the
retainer in the kneading blade is clogged, you can clean it carefully with a wooden skewer.
3.
Housing: gently wipe the outer surface of housing with a wet cloth. Do not use any abrasive cleaner
for cleaning, as this would degrade the high polish of the surface. Never immerse the housing into
water for cleaning. For easy cleaning, the appliance lid can be removed from the housing:
• Open the appliance lid to a suitable angle and lift up to remove it.
• Pull the appliance lid out of the hinge guides.
• To attach the appliance lid, pass the wedge-shaped hinge tappets through the opening in the hinge
guides.