Elba E 8550FG2 Series, Инструкции по использованию - Советы по установке, Страница: 9 / 36

9
It is important that the diameter of the pot
be suitable to the potentiality of the burner
so as not to compromise the high output
of the burners and therefore energy waste.
A small pot on a large burner does not give
you a boiling point in a shorten amount of
time since the capacity of heat absorption
of a liquid mass depends on the volume
and the surface of the pot.
Fig. 3.4 Fig. 3.3
LIGHTING THE BURNERS
To ignite the burner, the following instruc-
tions are to be followed:
1. Press in the corresponding knob and
turn counter-clockwise (fig. 3.2 ) to the
full flame position marked by the
symbol (fig. 3.1).
2. Models E 8550FG2-.. without elec -
tric ignition: light the burner with a
match or lighted taper.
Models E K58 .. 820 with electric
ignition : press the ignition button mar-
ked by the symbol (fig. 3.3). The
sparks produced by the electrodes si-
tuated next to the burner will light the
selected burner. In the case of a mains
failure light the burner with a match or
lighted taper.
3. Adjust the gas to the desired position.
To turn it off, turn the knob towards the
right, up to the safety click.
If your local gas supply makes it difficult to
light the burner with the knob set to maxi-
mum, set the knob to minimum and repeat
the operation.
CHOICE OF THE BURNER
On the control panel, near every knob, the-
re is a diagram that indicates which burner
is controlled by that knob.
The suitable burner must be chosen accor-
ding to the diameter and the capacity used.
As an indication, the burners and the pots
must be used in the following way:
DIAMETERS OF PANS WHICH MAY
BE USED ON THE BURNERS
BURNERS MINIMUM MAXIMUM
Auxliliary 12 cm 14 cm
Semi-rapid 16 cm 24 cm
Rapid 24 cm 26 cm
Triple-ring 26 cm 28 cm
Wok pan Max 36 cm
do not use pans with concave or con-
vex bases