5 DESIGN WASH 250 USER MANUAL V1.0 NR
2)
Carefully insert the lamp into the socket. Please remember there is only one way to insert the lamp.
Gently slide the lamp and its lamp holder back into place.
3)
On the access plate there are 3 screws marked 1,2 and 3.which are used to adjust the lamp
holder in the lamp housing. You can adjust the 3 screws to fine-turn the position of the lamp to
get the maximum light output as shown below.
A
B
Please remember the lamp is not a hot-restrike type, you must wait for approximately
15
minutes after
having turned off the lamp before you can turn it back on again.
CA UTION
Do not operate this device with open cover
b)
Mounting the device
CA UTION
Please consider the EN 60598-2-17 and the other respective national norms during the
installation. The installation must onl y be carried out by a qualified person.
The installation of the effect has to be built and constructed in a way that it can hold 10 times the
weight for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate safety
cable.
Never stand directly below the device when mounting, removing or servicing the fixture.
The operator has to make sure the safety relating and machine technical installations are approved by
an expert before taking the device into operation for the first time.
These installations have to be approved by a skilled person once a year.
