Elation CUEPIX 16IP DTW, Руководство пользователя

Страница: 7 / 32

7
S A F E T Y G U I D E L I N E S
DO NOT TOUCH
the fixture housing during operation. Turn OFF the power and allow approximately
15-minutes for the fixture to cool before servicing.
DO NOT
shake fixture, avoid brute force when installing and/or operating fixture.
DO NOT
operate fixture if the power cord is frayed, crimped, damaged, and/or if any of the power
cord connectors are damaged and do not insert into the fixture securely with ease.
NEVER force a power cord connector into the fixture. If the power cord or any of its connectors are
damaged and do not insert into the fixture securely with ease.
DO NOT block any air ventilation slots.
All fan and air inlets must remain clean and unblocked.
Allow approximately 6” (15cm) between fixture and other devices, or a wall for proper cooling.
When installing fixture in a suspended environment, always use mounting hardware that is no less than
M10x25mm, and always install the fixture with an appropriately rated safety cable.
Always disconnect fixture from main power source before performing any type of service and/or
cleaning procedure. Only handle the power cord by the plug end, never pull the plug out by tugging
the wire portion of the cord.
During initial operation of this fixture, a light smoke or smell may emit from the interior of the fixture.
This is a normal process and is caused by excess paint in the interior of the casing burning off from
the heat associated with the lamp and will decrease gradually over time.
Consistent operational breaks will ensure the fixture will function properly for many years.
ONLY use the original packaging and materials to transport the fixture for service.