Elan MAC24, Руководство по установке, Страница: 7 / 40

©2004 ELAN Home Systems. All Rights Reserved. 04/04. Page 7
ELAN HOME SYSTEMS
MUSIC AND COMMUNICATIONS
DISTRIBUTION CENTER
MAC24
INSTALLATION MANUAL
1. Distribution Center Installation
To mount the MAC24 into an ELAN SW Enclosure (E18, E32/G32) :
1. Remove power supply cover. Be sure not to lose
the screws once you remove them!
2. Install cable connectors into hole at bottom of the
MAC24 power supply compartment and into 3/4”
knock-out at bottom of E18 or E32 enclosure. It is
important that this be done now as access will
not be available once the MAC24 pan has been
attached to the grid. Replace power supply com-
partment cover when done.
3. Push ‘Snap Latch’ grommets (2) into the holes of
the MAC24 pan. Push ‘Snap Latch’ pins half-way
into grommets.
4. Hook pan to the grid from the top. See diagrams
below for installing the MAC24 into E32 and E18
enclosures. Different grill holes are used for each
enclosure.
5. Slowly swing pan into place. Metal nub and bot-
tom hook fit into grid holes, providing additional
support.
6. Push Snap Latch pins fully into grommets to lock
the MAC24 in place.
MAC24
Music & Communications
Distribution Amplifier
4 grid hole
from bottom
th
25 grid hole
from bottom
th
4 grid hole
from bottom
th
25 grid hole
from bottom
th
E18 enclosure
MAC24
Music & Communications
Distribution Amplifier
3 grid
hole from
the bottom
rd
22 grid
hole from
the bottom
nd
3 grid
hole from
the bottom
rd
22 grid
hole from
the bottom
nd
E32 enclosure
(cutaway view)
Plastic cable connector
Metal cable connector
Use 3/4” knock-
out at bottom of
enclosure
E32/E18
MAC24 power
supply compartment
2
MAC24
Music & Communications
Distribution Amplifier
Power supply compartment
Screw
1
Screw
4
5
3
Nub fits into
grid hole for
additional
support
NOTE:
A second Snap Latch
needs to be inserted
on the other side of
the MAC24 as well
Hook fits into
grid hole for
additional
support