16
14. Base Part Info and Installation
15. Belt Changing Method
Attention
After repairing the base part,
put the cabinet cover and push
it back and fix it with the four
corner screws .
Fix the base steel right into the
rubber seal strip before pushing
back the plastic base cover, then
tighten the screws of the plastic
cover.
!
1
Open basement
plastic cover
2
Loosen screws
and draw boards
unit out
3
Open boards
unit cover
1
Open basement
plastic cover
2
Loosen screws
and draw power
supply unit out
3
Open power
unit cover
Power Board
Basement Cover
Power
Supply Unit
Basement
Plastic Cover
Sealing Rubber Strips
Ignitor
DC380 PFC (below the ignitor)
24V Power Supply
Instructions
1. Open the arm covers [
1
2
]
2. Remove the center cover [
3
]
3. Remove the Y belt [
4
]
4. Remove the side screws [
5
]
5. Unplug the wire connector [
6
]
6. Reemove the light arm and body [
7
]
7. Remove the hexagon screws [
8
]
8. Remove the beam units [
9
]
9. Change X belt [
10
]
Screws
