GL-2081-M
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
Golight Radioray 2081-M Wireless Remote Control Spotlight
Handheld Remote - Magnetic Mount
Instruction Guide
The GL-2081-M Golight Radioray is designed for use in all weather conditions and
produces 1,300 lumens of intense light output. These units feature remote control
operation that allows users to rotate the light 370 degrees with a hard stop and to adjust
vertical tilt through 135 degrees. Remote operation is provided by a wireless hand held
remote control. The hand held remote measures 3 inches long by 2 inches wide by 3/8
inch thick.
MOUNTING INSTRUCTIONS
Light Unit/Magnetic Mount
Determine the location for the light on your vehicle or boat. The light is magnetically mounted with a
200lb. grip magnetic base that is tested to speeds up to 85 mph.
Note:
Once power is applied to the system the light will pan and tilt prior to illumination. Each
spotlight needs to be wired on a single dedicated circuit and the power fused at 5 amps. With the
power connected, your light is ready for operation.
POWER SUPPLY
Connect the SAE connector for power. Be sure this is securely fastened. Then plug the cigarette plug into a
compatible outlet providing 12V DC. The light is now powered and will operate with the remote control.
OPERATION OF SPOTLIGHT
1.
Using the remote control, turn on the light by depressing the on/ off button.
2.
With the arrows on the wireless control, rotate your light to the desired location.
3.
The speed of the light rotation can be controlled by depressing the fast/slow button one time
and by depressing it again to restore the original speed.
BATTERY INSTALLATION AND REMOVAL FOR TRANSMITTER
Remove battery cover: for
wireless hand-held transmitter, remove phillips head screw to remove cover. With battery
compartment now exposed, insert GP 23A 12V batteries according to the correct polarity or gently
remove batteries by grabbing the positive end and lifting up.
PROGRAMMABLE REMOTE INSTRUCTIONS
The Light is controlled with a programmable remote with 2187 different channels. This feature
allows you the freedom to change the channel selection, and the receiver re-learns the new
selection. This light has been pre-programmed at the factory, and it is not necessary to re-program
the transmitter, unless you experience outside interference.
To program transmitter:
1. IMPORTANT
Disconnect power.
2.
Remove battery cover from remote control.
3.
Set the 7 dip switches to a selection of your choice. There are 3 positions on each; positive,
negative and neutral. Use a small screwdriver and select a position for each dip switch.
*Please note that the orientation of the +/- switch positions may vary among different models
of wireless remote controls.
4.
Insert both GP 23A 12V batteries. Be sure batteries have adequate charge.
