INSTALLATION - continued
• Attach the speaker cables to the speaker terminals, observing the correct polarity
• Remove the grille from the speaker frame. The grille is held on by magnetic attraction. To remove simply
hold the edge of the grille and gently pull toward you.
• With the grille removed, the speaker can be inserted into the mounting hole. First make sure all the tabs
are rotated inwards and then connect the speaker wires. The connector posts are spring loaded so the
bare ends of the speaker wire can be pushed into the holes on the side of the post after the end cap is
depressed. Once inserted the end cap can be released and the wire will be held firm. Make sure no stray
strands of wire are exposed that could short across between the two posts.
• Use a Phillips head screwdriver – Turn each mounting screw clockwise to rotate the quick-turn mounting
bracket into place. Further turning of the screw will tighten the mounting bracket until it is firmly against
the wall. DO NOT over-tighten the screw to prevent breakage of the mounting bracket.
• When the speaker is mounted firmly in place, replace the magnetic grill
6
