3
1. Zones status LED
It indicates zones arming status.
•
ON
: no zones with alarm/tamper alarm events. The unit
can be armed.
•
OFF
: at least one zone not assigned to the exit path is
alarmed.
•
Blinking
: the unit is armed and at least one zone assigned
to the exit path signals an anomaly event; or at least one
zone signals alarm/tamper event but generates an event
different from intrusion alarm.
When the LED is off or blinking, the alarmed zones can be
displayed using ↓ key.
2. Anomaly status LED
It indicates anomaly status.
•
ON
: no anomalies. However, it is possible to configure
the LED so as it remains off when there are no anomalies
(via BrowserOne).
•
Blinking
: system anomaly (Mains failure, Low battery,
open Tamper or memory anomaly, etc.) or zones anom-
aly. For details on how to display anomalies, please see
paragraph 2.3.2
p. 5.
To reset memories, arm and disarm the system.
3. General alarm LED
It indicates general alarm.
•
OFF
: no alarm events.
•
ON
: alarm in progress (active relay).
•
Blinking
: alarm memories. To reset alarm memories, arm
and disarm the system.
4. Tamper LED
It indicates tamper status.
•
OFF
: no tampering zones.
•
ON
: tamper alarm in progress (active relay).
•
Blinking
: tamper alarm memories. To reset alarm memo-
ries, arm and disarm the system.
Once the system has been armed, if the option
Visualization Protection
is enabled in BrowserOne,
all status indications from LEDs will be disabled.
Acoustic signalling for tampered zones
The unit can be configured to emit a single or continued
acoustic signal ("Din Don") when one or more zones are in
anomaly condition.
2.2 Displayed information
The built-in keypad can control one (or more) pertaining
area(s) and can display its status. The display will show de-
tails of all areas, one by one.
Idle display
1
date
2
time
3
welcome message (default: empty)
4
arming status
5
temperature detected (from MDTEMP / from unit detector)
6
week day
7
radio signal strength
8
power status
9
e-Connect connection status
10
GSM signal status
FRI
21,4°
+21,7°
01/06/18
09:00
Disarmed
Welcome
1
2
3
4
5
6
7
8
9
10
Icons on top bar
icon
Indication
radio signal strength
radio signal strength in reception
mode.
1 bar
: poor
2 bars
: weak
3 bars
: good
4 bars
: excellent
Indication provided only during
transmission mode.
power status
Power status of related module.
OK
= no anomalies.
NO
= anomalies occurred.
e-Connect connection status
Status of e-Connect service
connection.
i
= e-Connect connection active
but unregistered unit.
i OK
= unit connected to
e-Connect server
i NO
= unit disconnected from
e-Connect server
GSM signal status
radio signal strength in reception
mode.
1 bar
: poor
2 bars
: weak
3 bars
: good
4 bars
: excellent
Indication provided only when
GSM module is registered.
To activate the display, press any keys. It will show the
pre-
senting area
as defined during keypad installation.