EL.MO. Spa NG-TRX LUPUS2K, Техническое руководство

Страница: 17 / 20

090001113
- TECHNICAL MANUAL -
LUPUS2K - VOLANS2K
international@elmospa.com
elmospa.com
17
Open the “ System options ” page, “ Options NG-TRX ” tab, where the general options of the NG-TRX devices are available.
Here you can select the settings that also involve the LUPUS2K and VOLANS2K transmitters.
The listed options are valid for all NG-TRX devices, except remote controls:
1. Delay supervision anomaly : NG-TRX devices generate the supervision failure event 6 supervision cycles later.
Example: if the default supervision timer is set to 240 minutes and the delay function is active, the supervision
anomaly is generated 24 hours later (240 minutes × 6).
2. Delay low battery signalling : if active, the devices run more thorough controls before sending the low battery signal.
3. Enable detection RF interference : this selection allows to detect interferences in the three 868 MHz channels and
to generate the event log. The interference detection on the preferred channel involves the transition to an other
channel if the same interference has already been detected and logged in the last 48 hours.
The general options selection about the 434 MHz interference detection does not concern NG-TRX devices.
4. RF Interference as Tamper : select this function to use an RF interference event to generate a tampering event, along
with the resulting management.
Selection of the multi-channel reception (3 channels), also involving the default/preferential channel selection and
the transmission strategy. In case the function is active but communication with the control unit is not possible, the
device will use one of the other two remaining channels. For more details see “13.4 Multi-channel reception and
strategy”.
The default channel shall be set by the installer, otherwise it is Ch1.
Note : the system uses the preferred channel based on the interference level; if there is no interference, the default
channel is used. Each channel change will be recorded in the event log.
Common supervision for all system devices,
except remote controls; if necessary, it can be
modified for each device.
1
2
3
4