Released on 1
st
of April, 2016.
STEP 4: PREPARING for mounting on fan
EK-XTOP Revo Dual D5 Come with mounting plates for
placing the unit on fan. You could place pump on 120mm
or 140 mm fan.
1. Secure Mounting plates on Holders with M4x12 and
plastic washers.
2. Secure pumps on fan with PT4.6x10 screws
2.1 If you place pumps on radiator use screws which came
with radiator.
STEP 5: ATTACHING FITTINGS
Screw in the fittings in the G1/4 threaded openings on plastic top. EKWB recommends using EK-ACF fittings with the EK-XTOP Revo Dual D5 series pump tops. To ensure that
the tubes are securely attached to the barb/fittings, please use hose clamps or an appropriate substitute.
It is mandatory to use the correct INLET and OUTLET ports:
1.
The OUTLET (pressure port) is the G1/4 threaded opening on the side of the pump top housing.
2.
The INLET (suction port) is the side of G1/4 threaded opening on the EK-XTOP Revo Dual D5 side face plane. Please refer to the picture on the right!
3.
Port with preinstalled plug can’t be used. It is technical hole.
Use reservoir to feed the pump in order to prime it
:
Connect reservoir
outlet
port with EK-XTOP Revo Dual D5
inlet
port!
This water pump & EK-XTOP Revo Dual D5 can be used in any mounting configuration (position) apart from being
mounted upside down!
Mounting the pump upside down may result in pump running dry and eventually lead to
premature failure of the pump!
IMPORTANT DISCLOSURES:
VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the computer. We
recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using tap water pressure. This will rupture the top of the housing and render
the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial possible, EK Water Blocks assumes no liability
expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks cooling products, either due to errors or omissions on
our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.
WARRANTY:Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During this
period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was purchased; (II) the product
has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled carelessly, or used in a manner other than in
accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other than those expressly set out above and does
not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not affect your statutory rights as a consumer. This warranty is
voided if the product comes in contact with aggressive UV additives or other improper liquids.
Any other RMA issues can be reported to
REQUIRED TOOLS
: Allen key 2.5mm and allen key 2mm ( Both are enclosed)
OK
OK
Mounted upside down?
NOT OK
!
INLET
Plastic washer M4
Screw M4x10,
Screw PT 4.6x10
OUTLETs to radiator or water block
