Released on 1
st
of April, 2016.
Installation and mounting manual for EK-XTOP Revo Dual D5
Serial
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at
for updates. Before installation
of this product please read important notice, disclosure and warranty conditions printed on the back of the box.
Before you start using this product please follow these basic guidelines:
1.
Please carefully read the manual before through before beginning with the installation process!
2.
The EK-HFB and EK-ACF type fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber o-ring gaskets.
3.
The use of corrosion inhibiting coolants is always recommended for any liquid cooling system.
STEP 1: PREPARING THE PUMP
STEP 2: PREPARING MOUNTING HOLES (if not installed on fan)
Unscrew the ribbed threaded ring that attaches the Laing pump’s
original factory top and the main pump core housing with motor.
Store the original top, the original o-ring gasket and the attaching ring
in a safe place.
First you have to prepare place where the pump will be installed.
Take enclosed stickers (2 identical) which each has 4 designated holes. Be careful that between outer
holes is 142mm as shown on picture bellow.
Stick it to the PC case where you want to place the pump. Be careful of correct pump position. (Step 5)
Take a drill (5mm) and drill 8 holes on designated points.
STEP 3: INSTALLING THE Dual XTOP AND HOLDER
Dual XTOP comes in four (4) port version. Pump Top has side inlet ports and side OUTLET ports (see the picture below).
1. Take the sealing gaskets [2] and place it on each pump [3].
2. When the sealing gasket is in place take the pumps and place them onto the XTOP [1]. You can rotate the XTOP to alternate the position of the OUTLETs PORT to meet your
requirements.
3. Fix the pumps [3] on the XTOP [1] using nuts [4].
4. Take the rubber dumpers [5] and place it into the Holders [6] as shown on the picture below.
5. When the Dumpers [5] are installed in to the Holders [6] push the assembled part onto the Pumps [3]. You can rotate the pump to alternate position of the outlet ports to
meet your requirements.
6. Take the Screws M3x12 [8] and tighten them to secure the pumps to the holders. You should use Allen Key 2mm along with the M3 threaded mounting plate [7] which is
preinstalled by EK.
7. Now you have successfully assembled the unit. Position the bottom Holder [6] holes on to the pre-drilled holes and secure the assembled unit using eight enclosed M4x10
screws and the PVC washers [9].
1
.
2
.
3
3
.
4
.
5
6
5
6
4
.
2
.
7
7
8
8
9
9
OUTLET to radiator or water block
INLET
Factory original
pump top
D5 pump body with
motor
Twist LEFT to unscrew!
Mounting holes
Scale not accurate
