All disclosures, notices and warranty conditions are being written on the EKWB website. Please read terms of use. Released on 15
th
of November, 2019; Revision 1
STEP 5: INSERTING THE CARD IN YOUR PC CASE
Carefully lift your graphics card with installed block and insert it in your PC’s motherboard PCI
-express expansion slot. Please bear in mind that your graphics card is probably
heavier than when it was equipped with original heat sink fan assembly. One needs to be very careful when handling the graphics card. Avoid all un-needed manipulation of the
VGA/water block assembly that might damage your card or water block during final installation.
STEP 6: CONNECTING THE RGB LED STRIP
CONNECTING THE D-RGB LED STRIP
REQUIRED TOOLS:
scissors
Philips head screwdriver
Plug the 4-
pin connector from Water block’s RGB LED light to the RGB_HEADER on the
motherboard. The LED will work if the pin layout on the header is as follows:
+12V G R B
.
Please ensure that the arrow indicated on the connector is plugged into
the +12V line as indicated on your motherboard.
Failure to do so will damage your motherboard or LED strip.
Plug the 3-
pin connector from Water block’s D
-RGB LED light to the D-RGB_HEADER on the
motherboard. The LED will work if the pin layout on the header is as follows:
+5V G R B
.
Please ensure that the arrow indicated on the connector is plugged into
the +5V line as indicated on your motherboard.
Failure to do so will damage your motherboard or LED strip.
