- 10 -
INSTALLATION OF FITTINGS AND TUBING
Screw in two male G1/4 threaded fittings. Attach the liquid cooling
tubes and connect the water-block(s) into the cooling loop.
EKWB
recommends using EK-STC or EK-HTC fittings with the EK-
Vector series water blocks.
TIf you are using barb fittings please
add hose clamps or an appropriate substitute to ensure that the
tubes are firmly secured.
You can configure any port as an inlet or outlet. Do not forget to plug
all remaining ports with the enclosed EK-Plug G1/4 or equivalents.
CAUTION:
If using fittings or plugs not recommending by EK take
special care to check the length of the male G1/4 threads. 5 mm is
the maximum allowed G1/4 thread length!
Tubing
EK-Fitting
EK-Plug G1/4
CONNECTING THE RGB LED STRIP (optional)
STEP 1
Plug the 4-pin connector from the water blocks RGB LED into the RGB
HEADER on your motherboard. The LED will work correctly if the pin
layout on the header is:
+12V G R B
.
Please ensure that the arrow indicated on the connector is
aligned with the +12V pin as indicated on your motherboard.
Failure to do so, will damage your motherboard or LED strip.
STEP 1
RGB Header
