- 8 -
INSTALLING THE WATER BLOCK
STEP 1
PLACING THE BLOCK ON TO THE GRAPHICS CARD
Carefully position the water block with preinstalled standoffs onto
the graphics card. During this process please make sure you align
mounting holes on the PCB with holes on the water block. Also pay
attention not to use too much force by pressing the block down onto
the PCB. Chip dies are prone to cracking. This procedure is the same
for all Full Cover water blocks.
STEP 2
ATTACHING THE BLOCK TO THE GRAPHIC CARD
Use a Phillips head screwdriver with the enclosed M2,5 x 4 AX1
screws. EKWB recommends users to start tightening the screws
evenly around the GPU core and then to continue outwards. Always
use a plastic washer under every screw.
STEP 1
STEP 2
In this step you will need:
Phillips-head
screwdriver
M 2.5 x 4 AX1
17 pcs
M 2.5 PVC washer
17 pcs
