Application manual
Presence detectors KNX EK
-
Dx2
-
TP (x = B, C, D, E)
Release 1.01
-
Update: 05/2014
MAEKDx2TP_EN
© SBS S.p.A.
–
All rights reserved
Page 12
Parameters:
Slave mode
(only available if
“
General /
Type
of detector” is “slave”)
Green LED
For test purposes, the green LED can be activated whenever movement /
presence are detected by the sensor.
Available values are
When motion
and
OFF.
The default value is
OFF
.
Value
Available values are
ON
and
OFF.
The default value is
ON
.
Idle time after switch off
Allows to avoid undesired flickering of the switched load after a change of
state.
The dead time can be set in the range from 1 to 60 s.
The default value is
5 s
.
Cyclical transmission
For systems having one master sensor and one or more slave sensors, it is
recommendable to periodically reset the master unit; it is therefore
recommended to leave the
Cyclical transmission
parameter always On.
The range of allowed values is either OFF or between 1 s and 4 h in
convenient steps.
The default value is
5 s
.
Parameters:
Evaluation of PIR
(only available if
“
General /
Type
of detector” is “slave”)
Active sensors
The three available PIR (Passive Infra
-
Red) sensors on the device can be
activated individualli or in partial groups. Numbers 1 to 3 match the sensor
positions shown in the figure “PIR sensor numbering” in section 5.7.
The default value is
123
(corresponding to all sensors active).
Sensitivity setting
Sensitivity can be adjusted on a scale from 1 to 10.
The default value is
5
.