EKF C20-SATA, Техническая информация

Страница: 20 / 28

Technical Information C20-SATA • SATA Dual-Drive Mezzanine Module
P1 SATA Cable Header
The C20-SATA can be optionally equipped with a vertical SATA signal header, suitable for latching
cable assemblies. P1 is exclusive to J3. Please note, that P1 would definitely violate the 4HP envelope
of the carrier board, with the attached cable in mind. P1 is provided as an option, e.g. for attachment
of a system internal drive such as an optical disk.
P1 • SATA • 256.007.21.01 Latched SATA Header
1 GND
2
3 SATA_TX-
4 GND
5 SATA_RX-
6
7 GND
TX/RX designation of signals are shown with respect to the SATA controller JMB362 on the carrier
board. A latching SATA cable assembly is highly recommended for reliable industrial usage.
SATA software drivers must be installed on the associated carrier card before using any SATA
connector on the C20-SATA.
Since P1 is exclusive to J3 (bottom mount drive), P1 is available only in the single drive configuration
of the C20-SATA. A right angled cable connector may be used for a minimum height assembly.
Lat
che
d S
A
TA
H
eade
r
25
6.0
07.2
1.01
©
EK
F
ekf
.c
om
C20-SATA
Side Board 4HP Pitch
Carrier Board PCB (Side Board)
SATA Latching Cable Assembly to System Internal Drive
6.0mm
18.72mm nominal
18.6mm hex nut
CPU Board PCB (Base Board)
4mm fem
2mm male
J1
J2
SSD/HDD Top Mount 7.0/9.5mm
P1
© EKF • ekf.com
© EKF -20- ekf.com