TECNOEKA Srl _____________________________________________________________ use and instruction manual
page. 20 __________________________________________________________________________________________
Should you wish to use specific products on the market, these must comply with the cleaning
requirements set out in the “General information” paragraph”.
It is worth remembering that the counter supporting the appliance or the floor surrounding the
area where the appliance is should also be cleaned without using acid corrosive substances (e.g.
muriatic acid) since the vapours released by them might corrode and deteriorate the outer steel
shell and cause irreparable damage to the electrical components inside the appliance.
5.6 Inactivity period
Should the appliance not be used for a long extent of time, it is good practice to disconnect it
from the power supply (act on the safety magnetic circuit breaker located upstream of the
appliance), the gas supply (close the stopcock on the mains) and water supply (close the
stopcock on the mains). It is recommended to clean it with care internally (cooking chamber)
and externally, paying special attention to removing any salt residues which might lead to
corrosion on the steel surfaces. It is also recommended to protect the appliance with oil-based
spray products (e.g. Vaseline oil) which form an effective protective film when sprayed on the
surfaces. Leave the door of the cooking chamber ajar.
Adequately covering the appliance, finally, allows it to be protected from dust.
6. Maintenance
6.1 General information
A periodic check (at least once a year) of the appliance contributes to extending its life and
assures proper functionality.
Any maintenance operation on the appliance must only be done by highly qualified personnel
trained in the operations to be performed.
Before performing any maintenance on the appliance, the power supply must be disconnected
(act on the safety magnetic circuit breaker located upstream of the appliance) and let it cool
down. The components that might require maintenance are accessible by removing the left side
and/or back of the appliance.
6.2 Lamp on door
Electrically disconnect the appliance. The lamp is housed between the two door glass panes.
Just open the inside glass pane to replace it. Replace the lamp with one having the same
functional features. The lamp is of the halogen type: it must not be touched with bare hands.
Close the internal glass again and connect to the power supply.
6.3 Door gasket replacement
The door gasket has a rigid profile with retainer fins. This profile must be inserted in the suitable
guide on the front of the cooking chamber.
To replace the gasket just remove the worn one from the guide (pull harder at the 4 corners).
Clean the guide from any dirt and insert the new gasket (it is advisable to moisten the gasket
profile with soapy water to make fitting easier).
6.4 Cleaning the fans
The fans must be regularly cleaned with appropriate descaling products. All their parts must be
thoroughly cleaned, eliminating any limescale. The fan cover must be removed to access fans.
When cleaning is completed fit the cover back on operating in reverse order.
Important
During the assembly of the fan-cover, pay attention to re-position properly, on its locations, the
2 pipes that introduce water to fans; in a different way, the pipes interfere with fans themselves
during the functioning, causing damages to the appliance, of which
The Manufacturer cannot
be held responsible
