- 13 -
STEP 2
STEP 2
Position the CPU Water Block onto the Motherboard. Make sure to
align the holes (as shown in the picture).
Before placing the water block, it is mandatory to remove
the protective foil from the backside.
Make sure to double-check the layer of the Thermal Grease
before placing the water block onto the motherboard.
STEP 3
Secure the water block from the backside of the motherboard using
the included Tx7 L-Shaped wrench.
Tighten the mounting screws in an anti-clockwise direction. Start
fastening the screws in a cross pattern. Do not tighten fully until all of
the screws are partially screwed in.
The Tx7 L-Shaped wrench must be used in a standing position!
Otherwise, the mounting screws may crack during tightening!
STEP 3
Tx7 L-Shaped wrench
For this step, you will need:
