11
Chapter 2 Configuring from the monitor screen
2-3. Setting Network Cameras
●
To automatically discover network cameras
Discover network cameras on the network automatically and register them to the system.
This procedure is for setting network cameras connected after performing “Easy Setup” upon initial
startup of the monitor.
Attention
•
Only the network cameras installed in the same subnet as the monitor are detected. If a network camera is
installed in a different subnet, the camera must be registered manually (see
“To manually register network
cameras” (page 12)
).
• When network cameras are not detected by automatic discovery, see
“Chapter 4 Troubleshooting” (page
66)
.
•
For information on “Easy Setup”, refer to the Setup Manual.
Procedure
1.
Select “Auto Discovery”.
Displays registered
cameras.
1
2.
Select “Start” at “Camera Discovery”.
The user authentication screen is displayed.
2
3
5
4
3. Enter the “Username” and “Password” specified in the network camera.
The following values are entered as the default settings:
-
Username: “admin”
-
Password: “12345”
These are the default settings for Panasonic network cameras. Change the settings if necessary. Please
contact your administrator for the username and password.
