20
Chapter 2 Installation / Connection
2-5. Installing the Cable Cover
1.
Align the cable cover on the back of the monitor in such a way that the cables
can go through the cable outlet port.
2.
Insert the cable cover tabs into the grooves in the monitor.
3.
Tighten the screws at the left and right holes on the bottom side of the monitor.
Screw hole
Cable cover
Cable outlet port
Tabs
Tabs
Cable cover reverse view
Attention
• Ensure that cables are not pinched between the cable cover and the monitor.
• Securely tighten the screws in the two locations. (Screw tightening torque: 0.4 N·m to 0.7 N·m)
• Avoid subjecting the terminal and cable to stress.
• Do not pack or transport if the cable cover is attached.
2-6. Turning On the Power
1.
Turn on the power switch at the bottom of the monitor, and then turn on the
monitor.
The power indicator in front of the monitor lights up green.
If the indicator does not light up, see “Chapter 3 If No Image Is Displayed” (page 21).
Note
• If the power switch at the bottom of the monitor is turned off, the monitor is turned off.
