17
Chapter 2 Installation / Connection
2-2. Installing the Product
This product should be installed using an arm or stand.
Attention
• When installing, do so by carefully following the information in the User’s Manual about the arm or stand.
• Ensure the following and select components that comply with the VESA standards.
- Clearance between the screw holes: 100 mm × 100 mm
- Strong enough to support weight of the monitor unit (excluding the stand) and attachments such as cables.
• Use the supplied screws when installing the product.
• When using an arm or stand, attach it to meet the following tilt angles of the monitor.
-
Up 45˚, down 45˚
• Connect the cables after attaching an arm or stand.
• The monitor, arm, and stand are heavy. Dropping them may result in injury or equipment damage.
•
Periodically check the tightness of the screws. If not sufficiently tight, the monitor may detach from the arm,
which may result in injury or equipment damage.
1.
Attach the arm or stand to the back of the monitor by aligning the four screw
holes and secure the arm or stand using the screws supplied with the monitor.
Screw tightening torque: 1.0 N
･
m - 1.4 N
･
m
Tool required: Phillips screwdriver (#2)
Rear
100
100
Screw holes
Using the supplied screws
Thickness of
lnstallation fixture
2mm
-
4.5mm
Installation fixture
Screw supplied with the monitor
Cabinet
Using commercially available screws
Installation fixture
Cabinet
Effective length
5mm
-
9mm
M4 screw
