EINHELL 4462168, Оригинальная инструкция по эксплуатации

Страница: 14 / 32

GB
- 14 -
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment’s construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Fitting the dust bag (Fig. 2)
Place the dust bag (6) on the dust bag connector
(5) and secure it by turning it.
The dust is extracted directly through the grin-
ding/sanding paper and the grinding/sanding disk
and into the dust bag.
Important.
For health safety reasons it is imperative that
you use a dust bag.
5.2 Fastening the abrasive paper (Fig. 5)
Easy replacement using Velcro fastening. Ensure
that the extractor holes on the abrasive paper and
grinding/sanding disc line up.
6. Operation
6.1 Switching the equipment ON/OFF (Fig. 3)
To switch on:
Push the ON/OFF switch (4) forwards.
To switch o ff :
Push back the ON/OFF switch (4) into its starting
position.
6.2 Speed control (Fig. 4/Item 3)
To pre-select the speed turn the knurled screw (3)
on the switch.
Plus direction: Higher speed
Minus direction: Lower spee
6.3 Working with the eccentric grinder/san-
der
•
Place the whole surface area of the sanding
disk on the material.
•
Switch on the machine and move it with gent-
le pressure over the workpiece completely
circular movements or moving it to and fro
and up and down.
•
Use a coarse paper for coarse sanding and
a finer paper for finish sanding . You can find
the best paper for the job by means of testing.
Important.
The dust generated when working with the machi-
ne may be harmful.
•
Always wear goggles and a dust mask when
carrying out sanding/grinding work.
•
Everybody who uses the machine or enters
the workplace must wear a dust mask.
•
Do not eat, drink or smoke at the workplace.
•
Do not use the machine on paints which con-
tain lead.
Anl_TC_RS_420_SPK8.indb 14 Anl_TC_RS_420_SPK8.indb 14 04.12.2017 07:50:37 04.12.2017 07:50:37