EINHELL 44.193.30, Оригинальная инструкция по эксплуатации

Страница: 19 / 126

GB
- 19 -
6.6 Overloading/overheating (Fig. 5/Item 6)
The battery charge level indicator (6) will light up
red if the equipment is overloaded. One expla-
nation for this can be that too much pressure is
exerted on the workpiece
Reduce the pressure.
If the equipment is overloaded for a lengthy pe-
riod, it switches o ff automatically. The LED then
fl ashes four times in succession
Switch the equipment on again and
reduce the pressure on the workpiece.
If the equipment gets to hot, it switches o ff auto-
matically.
Let the equipment cool down to room
temperature.
6.7 Description of the accessories:
The accessories which are used the most can be
kept on the charging station, as shown in Fig. 1.
Grinding pins (8):
In various grinding head shapes. For grinding and
deburring metal and plastic.
Recommended speed setting: 3 – 4
Cutting pins (9):
For c engraving plastic, wood, soft metal
and glass.
Recommended speed setting: 2 – 4
Pot brushes (10):
For cleaning stone, metal, aluminium, etc.
Recommended speed setting: 4 – 5
Cutter (11):
For cutting plastic, wood and soft metal.
Recommended speed setting: 2 - 4
Grinding/sanding belts (15):
For grinding/sanding wood and plastic.
See the illustration (6) for fi tting.
Recommended speed setting: 4 – 5
Polishing wheels (16):
For polishing brass, tin, copper, etc.
Also for use with polishing pastes.
See Fig. 7 for fi tting.
Recommended speed setting: 3 – 4
Cutting wheels (17/19):
For cutting metal and plastic.
Fasten the cutting wheel to the clamping spindle
(14). (see Fig. 8)
Recommended speed setting: 3 – 4
Grinding wheel (18):
For cleaning and sharpening blades and tools.
Fasten the grinding wheel to the clamping spindle
(14). (see Fig. 8)
Recommended speed setting: 3 – 4
Collet chuck key (20):
For mounting accessory tools.
Sleeves (21):
Various sizes for mounting di ff erent accessory
tools.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Anl_TE_MT_7_2_Li_SPK9.indb 19 Anl_TE_MT_7_2_Li_SPK9.indb 19 14.04.2020 10:34:50 14.04.2020 10:34:50