EINHELL 4300771, Оригинальная инструкция по эксплуатации

Страница: 10 / 20


Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety instructions.

CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
1.1 Special instructions for the laser
Important: Laser radiation
Do not look into the beam
Laser class 2
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the
equipment in any other way may result in
hazardous exposure to laser radiation.
Never open laser module.
When the crosscut saw is not going to be used for
an extended period of time, the batteries should
be removed.
Do not make any modifications to the laser that
are designed to increase the laser’s power.
The manufacturer cannot accept any liability for
damaged caused by a failure to comply with the
safety information.
2. Layout
2.1 Drag, crosscut and miter saw (Fig. 1-3)
1. Handle
2. ON/OFF
switch
3. Release lever
4. Machine head
5. Saw shaft lock
6. Movable blade guard
7. Saw
blade
8. Clamping device
9. Roller support with limit stop
10. Holding bar for roller support
11. Stop rail
12. Bench insert with scale for cutting length
13. Locking lever
14. Locking grip
15. Pointer
16. Scale
17. Turntable
18. Fixed saw bench
19. Scale
20. Pointer
21. Laser
22. Locking screw
23. Chip collection box
24. Drag guide
25. Fixing screw for drag guide
26. Laser battery compartment
27. Locking pin
28. Storage compartment for saw blades
29. Locking knob for storage compartment
30. Locking screw for workpiece support
31. Rubber buffer
32. Support foot
33. Extractor adapter
34. Knurled screw for limiting cutting depth
35. Stop for limiting cutting depth
3. Supplied package (Fig. 1. 5)
Drag, crosscut and miter saw
Clamping device (8)
Roller support with limit stop (9)
2 x Holding bars for roller support (10)
Chip collection box (23)
Allen key (A)
Allen key (B)
GB
10
Ꮩ
Anleitung_RT_SM_430_SPK7:_ 22.06.2010 15:47 Uhr Seite 10