5
1. Recommendations:
To prevent accidents it is best to make sure that
there are no small children in the direct vicinity during
the assembly work.
2. Important safety instructions
Wear safety gloves
when assembling the
aluminium profiles – sharp edges!
Wear safety gloves
when assembling the
aluminium profiles – risk of crushing!
Retighten all the screw connections after
about 2 weeks. Thereafter check the screw
connections every 3 months and retighten if
necessary.
3. Description of parts (see Fig. 1)
Item
Description Quantity
01
Angle section, 800 mm
8
02
Angle section, 615 mm
4
03
Diagonal strut, 150 mm
8
04
Metal shelf
6
05
Hex screw M6 x 10
40
06
Hex nut M6
40
07
Connecting piece, 50 mm
4
The dimensions (L x D x H) are approx. 800 x 615 x
800 mm.
If you should require more storage space you can
extend the table by screwing another table to the
connecting piece (7).
4. Installation notes:
To assemble, you will require a SW 10 mm open-
ended wrench.
Tighten the screws at the installation end first.
Refer to Fig. 1 and the illustrations in the following
installation text for each step you take to
assemble and install.
5. Assembly
1. First assemble the upper and lower frames (Fig.
2). It is imperative that you make sure that the
screw heads are on the inside (Fig. 3).
2. Screw the legs to the upper frame. Make sure that
the connecting pieces (7) are screwed onto one of
the longitudinal sides at the same time (Fig. 4).
It is imperative that you make sure that the screw
heads are on the inside on the short side of the
frame (Fig. 5).
3. Screw on the diagonal strut (3) (Fig. 6). It is
imperative that you make sure that the screw
heads are on the inside on the short side of the
frame.
4. Screw the lower frame to the legs. Make sure that
the connecting pieces (7) are screwed onto the
same longitudinal side as on the upper frame.
5. Align the frame horizontally once it has been
screwed together and then tighten the screws.
6. Place the metal shelves on the upper frame.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
Montageanleitung AT 1 SPK7 26.04.2006 8:42 Uhr Seite 5