EINHELL 34.112.20, Инструкция по применению

Страница: 15 / 70

radius of the grass trimmer the user is
responsible for any damage caused to third
persons by use of the trimmer.
Never cross roads or pebble paths with the grass
trimmer switched on.
When you are not using the grass trimmer, keep
it in a dry place out of the reach of children.
Use the grass trimmer only as described in these
directions for use and always hold it vertical to
the ground. All other positions are dangerous.
Check the screws regularly to see that they are
properly tightened.
Keep cables and other objects out of the area
you want to cut.
If you have to lift the grass trimmer to move it,
switch off the motor and wait for the rotating tool
to stop.
Before you connect the grass trimmer to the
power supply, make sure that none of its moving
parts are damaged and that the line spool is
correctly inserted and fastened.
Never cut against hard objects when using the
grass trimmer. This is imperative to avoid causing
injury to the user and damage to the trimmer.
Use only original replacement parts for repair and
maintenance purposes.
Examine the grass trimmer for signs of wear or
damage each time before you use it and after
any collisions. Have essential repairs carried out
without delay.
Always keep your hands and feet away from the
cutting mechanism, particularly when you switch
on the trimmer.
After pulling out new line, always return the
trimmer to normal working position before you
switch it on again.
Never use replacement parts or accessories
which are not foreseen or recommended by the
manufacturer.
Unplug the rechargeable battery before checking,
cleaning or doing any work on the machine and
when it is not being used.
Caution! The nylon line will run on for a few
seconds after the tool is switched off!
3. Explanation of the warning notice
(see Figure 2) on the grass trimmer
1: Caution!
2: Wear safety goggles!
3: Protect from the damp!
4: Read the directions for use before putting into
operation for the first time!
5: Keep third parties away from the danger zone!
6: The tool runs on after being switched off!
4. Technical data
Speed n
0
: 9.000 min -1
Cutting range: 25 cm diameter
Max. running period: approx. 25 min
Nylon cutting line Ø 1,2 mm
Type of protection: III
Sound power level LWA: 96 dB(A)
Sound pressure level LPA: 79 dB(A)
Replaceable NC battery: 14,4 V
Vibration A
w
: < 2,5 m/s 2
Power supply unit:
Mains voltage: 230 V ~ 50 Hz
Output:
Rated voltage: 18 V
Rated current: 400 mA
The noise level of this machine may exceed 85
dB(A). In this case, noise protection measures need
to be introduced for the user. The machine’s noise
was measured in accordance with IEC 59 CO 11,
IEC 704, DIN 45635 Part 21, NFS 31-031
(84/538/EEC). The level of vibrations emitted from
the handle is < 2,5 m/s
2 . Measurements were taken
in accordance with EN 786 part D: 1996+A1:2001.
GB
13
ANLEITUNG AT 14,4 01.02.2005 11:48 Uhr Seite 13