EINHELL 34.016.51, Руководство по эксплуатации

Страница: 14 / 38

GB
12
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
Use a brush to remove deposits from the safety
guard.
8.2 Replacing the line spool
Important. Make sure that you pull out the power
plug before exchanging the line spool!
앬 Undo the fixing screw (12) by turning it counter-
clockwise (Fig. 13).
앬 Remove the spool (11) (Fig. 14)
앬 Thread the ends of the line on the new line spool
through the eyelets (A) and insert the spool.
Tighten the fixing screw (12) by turning it
clockwise (Fig. 15).
Caution! Pieces of nylon line may cause injury
when flung out.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Spare line spool Art. no.: 34.057.15
9. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
10. Troubleshooting
The machine will not work:
Check that the power cable is connected properly
and check the mains fuses.
If the machine will not work despite the voltage
supply being OK, send it to the specified after-sales
service address.
Anleitung_BG_EB_1035_SPK1:_ 24.11.2008 14:17 Uhr Seite 12