EN
- 11 -
3. Intended use
The equipment is designed solely for waxing/
polishing and dewaxing paintwork on motor
vehicles, boats, caravans or mobile homes.
The equipment is allowed to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user/operator and not
the manufacturer will be liable for any damage or
injuries of any kind resulting from such misuse.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be voided
if the equipment is used in commercial, trade or
industrial businesses or for equivalent purposes.
4. Technical data
Motor power supply: ........................... 18 V
Idling speed: ............................ 2500 RPM (min
-1
)
Polishing disc: ........................... 10'' (Ø 254 mm)
Weight: .........................................4.6 lbs (2.1 kg)
Wear ear-mu
ff
s.
The impact of noise can cause damage to
hearing.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment‘s con-struction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear
protection is applied.
3. Health damage caused by hand-arm
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.
5. Before starting the equipment
The equipment is supplied without batteries
and without a charger.
5.1 Fitting the Lithium-Ion battery (not
included)(Fig. 4-5)
Push the battery into the battery mount provided.
When the battery is positioned as in Fig. 5, make
sure that the pushlock button latches in place! To
take out the battery, press the pushlock button
and remove the battery (Fig. 6).
6. Operation
Warning!
Always remove the battery pack before making
adjustments to the equipment.
6.1 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.2 Battery capacity indicator (Fig. 3)
Press the battery capacity indicator switch (7).
The battery capacity indicator (6) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED
fl
ashing:
The battery is empty, recharge the battery.
All LEDs
fl
ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depth-discharged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
Anl_CE_CB_18_254_Li_SPK7_USA.indb 11
Anl_CE_CB_18_254_Li_SPK7_USA.indb 11
04.05.2022 08:47:22
04.05.2022 08:47:22
