1. Tool illustration:
1: Torque adjustment facility
2: Bit holder
3: Forward / Reverse selector switch
4: On/Off switch
5: Rechargeable battery
6: Battery charger
7: Locking button
8: Pushlock button
2. Safety instructions
Please refer to the booklet included in delivery for
the safety instructions.
3. Important instructions:
It is imperative that you read these instructions
before you use your cordless screwdriver for the first
time:
1. Only ever recharge the rechargeable battery pack
with the battery charger included in delivery.
Empty batteries will require approx. 1 hour for
charging.
2. Only ever use sharp drill bits and screwdriver bits
which are suitable for the purpose and are in
faultless condition.
3. Always check for concealed electric cables and
gas and water pipes when drilling and screwing in
walls.
4. Putting into operation:
Loading the Ni-Cd battery pack
1.
Take the rechargeable battery pack out of the
handle (Fig. 2), pressing the pushlock buttons
at the side to do so.
2.
Check that the voltage on the rating plate is the
same as your supply voltage, then connect the
battery charger power cable to the socket
outlet.
3.
Slide the battery onto the battery charger (Fig.
3). The red LED indicates that the battery is
being charged. The green LED will come on
when charging has been completed. Empty
rechargeable batteries will require approx. 1
hour for charging. The rechargeable battery
pack may warm up a little during charging but
this is perfectly normal.
If the battery pack fails to become charged, please
check
whether there is voltage at the socket-outlet
whether there is proper contact at the charging
contacts on the charger.
If the battery still fails to become charged, please
return
the charger
the battery pack
to our Customer Service Department.
Timely recharging of the Ni-Cd battery pack is
recommended in the interest of long battery life.
Recharging is always necessary when you notice
that the power of the battery-powered
drill/screwdriver is decreasing.
Never allow the battery pack to discharge
completely. This will result in damage to the Ni-Cd
battery pack!
Adjusting the torque (1)
The battery-powered drill/screwdriver is equipped
with a 16-step mechanical torque adjustment facility.
The torque for a specific size of screw is selected
with the set-collar. The correct torque depends on
several factors:
on the type and hardness of material in question
on the type and length screws used
on the requirements needing to be met by the
screwed joint.
The clutch disengages with a grating sound to
indicate when the set torque is reached.
Important! The tool must be at a standstill when
you set the torque with the setting ring.
Drilling
For drilling purposes, move the set-collar to the last
step „Drill“. In this setting the slip clutch is inactive.
The maximum torque is available in drilling mode.
Forward/Reverse switch (3)
With the slide switch above the On/Off switch you
can select the direction of rotation of the battery-
powered drill/screwdriver and secure it against being
switched on accidentally. You can choose between
clockwise and anticlockwise rotation. To avoid
causing damage to the gearing it is advisable to
change the direction of rotation only when the tool is
at a standstill. The On/Off switch is blocked when
the slide switch is in centre position.
7
GB
Anleitung E-AS 18-2-1H SPK 7 04.08.2004 9:30 Uhr Seite 7
