7
GB
1. Description
1
Power cable
2
Locking button
3
On/Off switch
4
Knurled screw for regulating the speed
5
Inspection guard
6
Saw blade
7
Guide roller
8
Adjustable base
9
Selector switch for pendulum action
10 Adapter for chip extractor
11 Allen key
12 ON/OFF switch for laser/LED
13 Parallel stop
2. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Important! Laser radiation
Do not look into the beam
Laser class 2
Protect yourself and your environment from acci-
dents by taking the appropriate precautionary mea-
sures.
앬
Do not look directly into the laser beam with the
naked eye.
앬
Never look directly into the laser path.
앬
Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
앬
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
앬
Never open the laser module.
앬
When the device is not going to be used for an
extended period of time, the batteries should be
removed.
3. Use
The jigsaw is designed for sawing wood, iron, non-
ferrous metals and plastics using the appropriate
saw blades.
4. STARTING UP
Instant response operation
(Figure 1)
Switching on: Press the On/Off switch
Switching off:
Release the On/Off switch
Continuous operation
Switching on:
Press the On/Off switch, keep pres
sed and lock with the locking button
Switching off:
Press the On/Off switch and release
Electronic speed control setting (Figure 1)
Using the knurled screw on the On/Off switch you
can pre-set any speed. Turn the knurled screw in
PLUS direction for a higher speed and turn it in
MINUS direction for a lower speed. The ideal cutting
rate depends on the specific material and working
conditions.
The general rules for tool speed in cutting operations
apply.
Setting the pendulum action (Figure 1)
Position 0: No pendulum aktion
Position 1: Slight pendulum action
Position 2: Moderate pendulum action
Position 3: Intensive pendulum action
Dust extraction (Figure 1)
The jigsaw is equipped with an adapter for the vacu-
um cleaner connection. Any vacuum cleaner can be
connected to the extraction opening at the rear end
of the jigsaw. Should you require a special adapter
for this purpose, please contact the manufacturer of
your vacuum cleaner.
Changing the saw blade (Figure 2)
Switch off the jigsaw and remove the plug from the
power socket before changing the blade or carrying
out any other work on the jigsaw.
Use the supplied hexagon-socket spanner to undo
the two screws on the ram (Figure 2). Slide the saw
blade into the guide slot and up to the stop between
the piston rod and the retention clip. Use the
supplied hexagon-socket spanner to tighten the two
Ꮩ
Anleitung BPS 800_FA.qxd 12.07.2006 16:18 Uhr Seite 7