DIVA T/A ISDN Modem User’s Guide
◆
Page 10
Windows 95/98/NT Installation and Setup
Windows 95 (Original Release and SP1)
This install procedure is for the original release and Service Pack 1 (SP1) version of
Windows 95. If you are using Windows 95 Service Release 2 (OSR2), go to “Windows 95
(OSR2)” on page 12.
To verify the version installed on your machine, click ‘Start’, ‘Settings’, ‘Control Panel’, ‘System’,
then click the ‘General’ tab. If you have the original or SP1 version of Windows 95 installed,
you will see ‘4.00.950’ or ‘4.00.950 A’, as shown.
DUN 1.2 or Later Required
If you are using Dial-Up Networking (DUN), make sure you are using version 1.2 or later. If you
are running a previous version, you must upgrade to DUN 1.2 or later before installing the
DIVA T/A. For your convenience, DUN 1.3 is included on the DIVA T/A CD-ROM; run SETUP.EXE
from the CD-ROM and click ‘Bonus Software’.
Setup Instructions
Follow these steps to set up the DIVA T/A under Windows 95 (Original Release and SP1).
1
Power on your PC with all cables connected (see page 7 for instructions).
2
Windows 95 detects the DIVA T/A and the ‘New Hardware Found’ window appears.
3
Insert the DIV AT/A CD into your computer's CD drive.
4
In the ‘New Hardware Found’ window, select ‘Driver from disk provided by hardware
manufacturer’ and click ‘OK’. The ‘Install From Disk’ window appears.
