EIBENSTOCK ERF 14.2 S, Оригинальное руководство пользователя

Страница: 18 / 40

18
!
Attention!
If the machine stops for any reason or due to power failure,
immediately release the arrestor button by pressing the
ON/OFF switch, to avoid sudden starts in unattended
condition (physical hazard).
The Renotool is equipped with an electronic switch. With this switch the
speed can be regulated according to the pressure on the button. Permanent
use with reduced speed can cause an overload because the motor then
gets less cooling air and therefore the machine will be overheated much
faster.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance. However, the following points always have to be
observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Environmental Protection
Raw material recycling instead of waste disposal
To avoid damages on transportation, the power tool has to be delivered in a
sturdy packing. The packing as well as the tool and its accessories are
made of recyclable materials which makes it possible to remove
environmental friendly und differentiated because of available collection
facilities.
The tool’s plastics components are marked according to their material,
which makes it possible to remove environmental friendly and differentiated
because of available collection facilities.