EIBENSTOCK EMH 650, Оригинальное руководство пользователя

Страница: 14 / 20

14
This power tool is supplied with single–phase AC voltage.
Before starting the machine, please check the correspondence between
voltage and frequency against the data mentioned on the identification
plate. Voltage differences of + 6 % and – 10 % are allowed.
The hand-held drilling machine is made in protection class II.
Only use extension cables with a sufficient cross section. A cross section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
Tool Protection
Wrong handling can cause damages on the tool and injuries of the user.
Therefore, the following instructions should be observed:
Only used original SDS-plus Chisel
Starting Operation
WARNING:
At
low temperature ≤ 0оC (32оF) or if the power tool has not been
used for a long period (after storage in warehouse / shop / house)
there might be no impact action at start because of the thickened
lubricant. In this case, let the power tool run for 1.5 minutes at no load
in order to warm up, thus achieving improved lubrication and
prolonged life of the power tool.
Switching on and off
Short-Time Operation
Switching-on: press the on/off switch
Switching-off: release the on/off switch
Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off: press the on/off switch and release it again
!
Attention!
In case of every stop of the machine, the lock-on button has
to be released immediately by pressing the on/off switch.
Consequently, you can avoid an unintentional restart of the
machine (physical hazard).
Electrical Connection