EIBENSTOCK EHR 18.1 S SET, Оригинальное руководство пользователя, Страница: 15 / 48

15
Tool Protection
Wrong handling can cause damages on the tool. Therefore, please always
observe the following instructions:
Only use stirring rods with M14 - internal thread which are recommended by
the producer.
Please consider the max. basket diameters.
Do not allow blocking of the tool.
Only use original accessories made by EIBENSTOCK.
Switching on and off
Short-Time Operation
Switching-on: press the on/off switch
Switching-off: release the on/off switch
Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage the
arrestor button
Switching-off: press the on/off switch and let it go off again
!
Attention!
In case of every stop of the machine or a power cut, the
lock-on button has to be released immediately by pressing
the ON/OFF switch. So you can avoid an unintentional
restart of the machine (physical hazard).
The stirrer is equipped with an electronic switch. With this switch the speed
can be regulated according to the pressure on the button. Only use the
electronic switch when you want to start or stop the machine in order to
avoid material splashing around. Permanent use with reduced speed can
cause an overload because the motor then gets less cooling air and
therefore the machine will be overheated much faster.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only be appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance. However, the following points always have to be
observed:
Always keep the power tool and the ventilation slots clean.