EIBENSTOCK EFB 152 PX, Оригинальное руководство пользователя, Страница: 19 / 24

19
Use
Preparation
Use the cover plate for holes up to 40 mm in
diameter. The cover plate must be removed
for holes larger than 40 mm.
Drilling
Put the tile or plate you want to drill on the drilling
table and adjust it.
Fix the workpiece with the hold-down which fulfils the
task as a splash guard as well.
Attention!
The tile might break or move!
Work carefully!
The height of the hold-down can be adjusted
according to the material.
For this purpose, loosen the wing srew and pull out
the screw. Adjust the requested height of the hold-
down, insert the screw again and lock it.
Adjust the speed, which is correct for the drill bit diameter, on the adjusting
wheel and switch the machine on. Please decide in accordance with the
information of the drill bit manufacturer.
Press the switch on the machine. Pump and machine start at the same
time. The amount of water can be regulated via the mini ball valve at the
pump. Do not start working until enough water is running from the drill bit.
Attention!
The workpiece might slip while drilling. Work concentrated!
Put the drill bit gently on the workpiece and drill with a low feed rate in
order not to break the tile.
Removing the workpiece
Close the water supply and switch the machine off.
Attention!
The drill bit has a lag when you have switched the machine off.
When removing the tile, please pay attention that its drilled
edges are sharp.