EIBENSTOCK EFB 152 PX, Оригинальное руководство пользователя, Страница: 17 / 24

17
Tool Protection
Wrong handling can cause damages on the tool and injuries of the user.
Only use accessories recommended by the manufacturer.
By means of a thermal sensor, in case of continuous overload, the motor is
protected against destruction. In fact, the machine switches off
automatically and only can be switched on again after a certain cooling
period (about 2 minutes). Press the on/off switch. The cooling period
depends on the heating of motor winding and ambient temperature.
Only use original accessories made by EIBENSTOCK.
Drill Bits
Drill bits with an external thread R ½“ can be screwed directly in the work
spindle. Always use drill bits matching the material which has to be drilled
.
You can treat the machine carefully by using only drill bits that are balanced
and undeformed.
Pay attention that the segments of the tool have enough relief cut toward
the drill bit body.
The pump is equipped with a filter sponge to protect it
against dirty cooling water.
This should be cleaned regularly.
To clean the pump, take off the push-on grille, remove
the sponge and clean it with clean water.
Drain the drip pan with plug from inside sealed!