3
If fixing to a wall, the screws should be spaced 95mm (3.7 inches) horizontally apart. The top screws
will be 70mm (2.7 inches) below the top surface of the Strobe Module when installed. The template at
the end of this leaflet can be used to locate the screws accurately. The screws (large heads) should
be screwed into the wall leaving a gap of approximately 4mm (0.15in) under the head. Fit the keyhole
slots on the back of the Strobe Module over the screw heads and slide the panel down vertically into
position.
Battery
Battery
Plug
Latch
Figure 2
Battery
Clearance
Notch
Figure 3
Shows battery orientation - Dress the battery leads as shown, replace the battery
cover and push firmly down on the two latches
